- Hardware Manuals
- Commissioning and Tuning Guide
- Software Reference
- Resources
The Sin/Cos Encoder Cable Adapter is an interface board which can be used to convert Sin/Cos encoder signals to BiSS Protocol.
This feature can be used by any board that supports BiSS, for example SOMANET Node rev. D.4/E.1 or SOMANET Circulo.
Pin |
Signal |
Direction / Comment |
---|---|---|
1 |
5 V* |
Output max. 100 mA |
2 |
SIN + |
Input |
3 |
COS + |
Input |
4 |
ZERO + |
Input |
Pin |
Signal |
Direction / Comment |
---|---|---|
1 |
ZERO - |
Input |
2 |
COS - |
Input |
3 |
SIN - |
Input |
4 |
GND |
5 V return |
The interface connector comes with a cable which will be connected to the encoder port that features BiSS.
For connecting, please use a flat ribbon cable with 1.27mm pitch.
Pin |
Signal |
Direction / Comment |
---|---|---|
1 |
MA- |
Input |
2 |
+5V |
Input |
3 |
GND |
5V Return |
4 |
MA+ |
Input |
5 |
SLO- |
Output |
6 |
SLO+ |
Output |
The PCB can be shrinked to a shrink tube with a diameter of 20 mm.
The board will be delivered with a strain relief. A cable tie can be used as a strain reliever:
On the right side of the image, the cable tie is symbolized in red and the cables in black. The Synapticon Logo can be connected to PE, e.g. the shield of a cable. There is the possibility to place a CAP and a resistor between PE and GND. In Standard version this is not placed.
If not needed, the strain reliever part can be broken off, then the module is shorter.
Cables can also directly be soldered to the PCB. If this option is needed, please contact sales@synapticon.com