Technical Specifications¶

Power Specifications¶

Power Specifications
Node Size	Node 400	Node 1000
Maximum Peak Output Power	415 W	1,040 W
Maximum Continuous Output Power	415 W	1,040 W
Nominal Supply Voltage	12-48 V DC
Maximum Supply Voltage	60 V DC
Minimum Supply Voltage	10 V DC
Maximum Input Current DC	9.6 A DC	24A DC
Maximum Phase Current RMS	13.2 A RMS	33 A RMS
Efficiency (at Maximum Power)	98 %
Brake control power output	0-48 V PWM Phase D

General specifications
Supported Communication Standard	EtherCAT
Number of Phases	4
Supported Motors	1 x 3-phase BLDC-Motor and 1 active brake
	Up to 2 Brushed DC Motors 1
Brake control voltage	0-48 V PWM Phase D
Analog Inputs	4 (2 x single-ended 0-10V, 2 x differential ±5V) 2
Digital IOs	4 × GPIO / SPI 3 / I ² C 3 (3.3 V CMOS logic) 4
Encoder Connectors	2 x 4ch. RS-422
Supported Standard Encoder Interfaces	Incremental Encoder (ABI), HALL, BiSS-C, SSI, SPI 3, I ² C 3
Incremental Encoder max frequency	1.4 MHz 5 (supports up to 14,000 rpm with a 4,096 resolution incremental encoder)
Hardware Protections	Overcurrent, Overvoltage, Undervoltage, Temperature
Compliance with standards	CISPR 11 Class B IEC 61000-4-6 IEC 61000-4-3 IEC 61000-4-2 IEC 61000-4-8
Dimensions	70 x 40 x 21 mm
Weight	85 g (incl. Heatsink)
Operating temperature	0 to 50 °C
Storage Temperature	-35 to 85 °C
Max. installation altitude	2000 m
Humidity	5-85% rH
Sensors on-board	DC-BUS Voltage, DC-BUS current, Phase Voltage, Phase current (two phases measured, one computed), Temperature

1: Currently not supported by our standard software. Can be developed upon request, please contact sales@synapticon.com
2: All Analog Inputs can be configured as single-ended 0-5 V, 0-10 V, 0-20 V or differential ±5 V, ±10 V independently. Upon request only, please contact sales@synapticon.com
3(1,2,3,4): Upon Request
4: Two Digital IO can be configured as 5.0 V CMOS logic. Upon request only, please contact sales@synapticon.com
5: Depends on the firmware used. Value given for v4.1