Using the safety functions¶

Timing diagrams¶

Timing diagram for STO-function without SBC¶

Timing diagram for STO-function with SBC-function¶

../../../../../_images/timing_sto-sbc2.png

Truth table for digital inputs¶

Digital input STO-SBC 1	Digital input STO-SBC 2	Internal fault	Safety Statusword	Error entry
0	0	no	1
0	1	no	1	“SfeDilvd”
1	0	no	1	“SfeDilvd”
1	1	no	0
0	0	yes	1	“SfeFault”

Diagnostic functions¶

Software diagnostics¶

The safety circuit has two integrated diagnostic functions:

Comparing safety digital input statuses. The fault is activated after 100ms discrepancy of the STO-SBC inputs. In case a fault is detected, the servo drive will stop the motor and indicate a fault “SfeDilvd” in the Error Report object.
During the activation of the STO-SBC function the servo drive verifies that the two channels of the module are internally operating correctly. In case an internal fault is detected, the servo drive will stop the motor and indicate a fault “SfeFault” in the Error Report object.

Hardware diagnostics¶

The STO-SBC feedback is a hardware feature that outputs a signal when both digital inputs have received the STO-SBC signal correctly.

STO-SBC status register¶

The Safety Statusword indicates the current state of safety functions and Safety Digital Input Diagnostics shows the state of the safety inputs.

Index	Name	Descriptions
0x6621	Safety Statusword	Subindex: 1 - Bit 1: STO status is the first bit of byte 2 - Bit 2: SBC status is the first bit of byte STO/SBC status: 0: is not active 1: is active
0x2611	Safety Digital Input Diagnostics	Subindex: 1 - Input 1: 2 - Input 2: Input 1/2: 0: Input is low 1: Input is high

Index

Name

Descriptions

0x6621

Safety Statusword

Subindex:

1 - Bit 1: STO status is the first bit of byte

2 - Bit 2: SBC status is the first bit of byte

STO/SBC status:

0: is not active

1: is active

0x2611

Safety Digital Input Diagnostics

Subindex:

1 - Input 1:

2 - Input 2:

Input 1/2:

0: Input is low

1: Input is high

Note

Using the SBC function while running the motor may damage the brake due to mechanical stress. During normal operation it is recommended to activate STO-SBC after the motor has come to a halt e.g. by introducing a delay with an external safety logic device such as a safety timer. This way an equivalent of SS1 with time monitoring is implemented.

Attention

The STO-function does not provide electrical isolation from the mains supply. If electrical changes need to be carried out on the system (e.g. modifying the motor cabling), the servo drive shall be completely isolated from mains supply with a mechanical switch.