Cyclic Synchronous Velocity Mode

The velocity control modes allow the EtherCAT master to send desired velocities to the SOMANET drive. The drive will make sure these velocity values are reached by the motor (if the motor is physically able to do so).

In this mode, the trajectory generator is located in the control device, not in the servo drive. In a cyclic synchronous manner, it provides a target velocity to the drive device, which performs velocity control and torque control. If desired, the position control loop may be closed over the communication system. Optionally, a torque offset may be provided by the control system in order to allow a second source for velocity and/or a torque feed forward.

Position sensors are supported and the velocity may be calculated by taking the derivative.

The cyclic synchronous velocity mode covers the following sub-functions:

  • demand value input;

  • velocity capture using position sensor;

  • velocity control function with appropriate input and output signals.

The behavior of the control function is influenced by control parameters such as limit functions, which are externally applicable.

../../../../../_images/csv_overview.png

The figure above shows the inputs and outputs of the drive control function. The input (from the control device point of view) are the target velocity and optionally a torque offset. The drive control function in the diagram contains both the velocity controller and the torque controller, where the output of the velocity control loop is used as an input for the torque control loop.

The drive device supports limitation of motor speed and a quick stop function for emergency reasons.

The velocity actual value is used as mandatory output to the control device. Another output is the torque actual value.

All values are in rpm by default.